ABB COMMANDER 300 Operating Instructions Manual page 15

8.6.1 General Parameters...
Parameter
Time Units
Cycle Time
Hysteresis Value
Proportional Band
Integral Action Time
Derivative Action Time
Approach Band
P.I.D. Offset
Local Set Point Adjust
Enable
Local Set Point High
Limit
Local Set Point Low
Limit
Local Set Point
Set Point Tracking
Enable
Set Point Type Select
State
Second Set Point State
Dual Set Point High
Limit
Dual Set Point Low
Limit
Remote Set Point High
Limit
Remote Set Point Low
Limit
Ratio Adjust Enable
(Remote Set Point)
Ratio Adjust Value
(Remote Set Point)
Bias Adjust Enable
(Remote Set Point)
Bias Adjust Value
(Remote Set point)
Select Set Point Type
Command
Mnemonic
Read
(R)
Control Page Parameters
TU Yes
CT Yes
HY Yes
PB Yes
IT Yes
DT Yes
AB Yes
OF Yes
Set Point Parameters
SE Yes
SH Yes
SL Yes
LP Yes
TE Yes
TS Yes
UE Yes
UH Yes
UL Yes
MH Yes
ML Yes
RE Yes
RO Yes
BE Yes
BO Yes
TY Yes
8 COMMUNICATION...
Reply Interpretation
Write
(W)
Yes 0 = Seconds
1 = Minutes
Yes 1.0 to 300.0 seconds (0.9 = ON/OFF)
Yes 0.0 to 5.0(%)
Yes 0.1 to 999.9
Yes 1 to 7200 seconds, 7201 = OFF
Yes 1 to 999.9 seconds, 0 = OFF
Yes 0.1 to 3.0
Yes 0 = 0.0
1 = 50.0
Yes 0 = No
1 = Yes
Yes Any value within the programmed display range
Yes Any value within the programmed display range
Yes Any value within the programmed display range
Yes 0 = No
1 = Yes
Yes 0 = No
1 = Yes
Yes 0 = None
1 = Dual
2 = Remote
Yes Any value within the programmed display range
Yes Any value within the programmed display range
Yes Any value within the programmed display range
Yes Any value within the programmed display range
Yes 0 = No
1 = Yes
Yes 0.010 to 9.999
Yes 0 = No
1 = Yes
Yes –100 to +100
Yes 0 = Local
1 = Balance
2 = Second
13