Remote control operation and Liquid Crystal Display
1 ) ON/OFF
Press the
/ON/OFq
button to operate the unit.
2) Operating mode selection
Select the desired operating mode with these buttons: [coOL/DRY~ or
FAN-1
3)
Room temperature setting
Each time the
I
WARMER1 button is pressed, the set temperature rises by 2 deg.
Each time the
- 1
button is pressed, the set temperature falls by 2 deg.
If the
1
WARMER
/
or
j
button is continually pressed, the set temperature rises or falls by 2 deg. per 0 . 5 sec.
4) Timer operation
a l f the
- 1
button is pressed, the modes change in the following order :
(AUTO STOP)
-
(AUTO START)
-
(TIMER OFF), and the respective modes are displayed on the liquid crystal display
panel.
Air discharge display
(A) 2 0 deg. discharge
( B ) 45 deg. downward discharge
(C) 60 deg. downward discharge
(D) 7 0 deg. downward discharge
OTime setting
Timer time can be set by the
[ I
button. Each time the
/I
button is pressed, the time increases by 1
hour. If the
1
1
button is continually pressed, the time increases by 1 hour pr. 0 . 5 sec. Time setting is in 1 hour
units for up to 2 4 hours.
L
-
J
In coollng mode, the 45 deg downward discharge
IS
available only whlle the fan speed
IS
HIGH
In this example, the AUTO STOP is selected and 8 hours later the air
conditioner will be turned to off. The time display will change in 1 hour
7 )
Louver operation (AIR SWEEP (For PC/PCL/PK/PKL series))
Press the AIR SWEEP
/ m / m
button to turn the louver operation (air sweep) ON or OFF.
BE#
During "AIR SWEEP" ON, the display alternates every second
:
. r ,
-
8) "Self-diagnostic" function ( W C H E l )
Press the
HECK^
button twice to start the "self-diagnostic" function. "Unit address" and "check code" are alternately
displayed in the set temperature display.
9)
"TEST RUN" mode
Press the
I
TEST RUN
/button twice to start the test run mode. The TEST RUN is easily available, regardless of season.
-
AUTO STOP
~ / H R I I ~ ~ ~ p
e
~
~
~
units, showing the remaining time.
LCD
.The
timer mode automatically memorizes the previous time setting. When the timer mode is repeatedly used, the
previous time setting is set automatically. (Use the
- 1
button to change the time setting)
@Timer cancel device
To cancel the timer setting, push the POWER
button.
5 ) Fan speed
Press the
~LOW/HIGH/
button to change between low and high speed, "LOW" or "HIGH" is displayed according t o the
mode.
6) Air discharge selection (the angle of auto vane) (For PVPLL series)
Press the [UP/DOWN button to select the air discharge direction among the following air discharge setting.