Mitsubishi Electric PL18FK2 Service And Parts Manual page 109

14-5 Outdoor unit (PU24EK)
OPERATING PROCEDURE
1
.
Electrical parts
(1) Remove top panel (3 screws in front, 2 screws in
rear)
(2) Remove panel cover (1 screw).
The panel is clasped to the side panel.
Remove by pulling towards you.
(3) Remove service panel (1 screw).
The panel is clasped on the right and left sides.
After removing the screw, pull the panel down and
remove it by pulling towards you.
2. Blower motor
(1
)
Remove front panel (3 screws).
Open the panel to a 45 degree angle and lift to
remove. The panel is clasped at three points on the
left side.
(2)
Remove propeller fan (1 set nut).
(3) Remove fan motor (3 screws).
Remove lead connectors.
PNOTOS
Screws
Photo 1
Photo
2
Compressor protector
\
Run capacitor
Screws
/52C relay
>rrninal block
Motor support
Separator support place
Photo 3
!
Propeller
I
High- press1
switch
'Valve bed
ure
/
Propeller
Crank case heater
1 0