Volt-Ampere Curve; Connecting To Weld Output Terminals - Miller Millermatic 350P Owner's Manual

3-3. Volt-Ampere Curve

90
80
70
60
50
40
30
20
10
0
0 50

3-4. Connecting To Weld Output Terminals

Tools Needed:
3/4 in. (19 mm)
!
Turn off power before connecting to
weld output terminals.
!
Failure to properly connect weld
cables may cause excessive heat
and start a fire, or damage your ma-
chine.
OM-1327 Page 12
.
A complete Parts List is available at www.MillerWelds.com
100 150 200
AMPERAGE
4
1
Do not place
anything between
weld cable terminal
and copper bar.
2
3
Correct Installation
1 Weld Output Terminal
2 Supplied Weld Output Terminal Nut
3 Weld Cable Terminal
4 Copper Bar
Remove supplied nut from weld output ter-
minal. Slide weld cable terminal onto weld
M AXVO LTS
M INVOLTS
250 300 350
output terminal and secure with nut so that
weld cable terminal is tight against copper
bar. Do not place anything between weld
cable terminal and copper bar. Make
sure that the surfaces of the weld cable
terminal and copper bar are clean.
1 Normal Volt-Ampere Curves
The volt-ampere curves show the
normal minimum and maximum
voltage and amperage output
capabilities of the welding power
source. Curves of other settings fall
between the curves shown.
217 443-A
803 778-A
Incorrect Installation