Rear Brake Adjustment; Front Brake Pad Inspection And Replacement - Yamaha YZ125N1 Service Manual

FRONT BRAKE PAD INSPECTION AND REPLACEMENT

REAR BRAKE ADJUSTMENT/

EC364002
REAR BRAKE ADJUSTMENT
1. Check:
9 Brake pedal height a
Out of specification Adjust.
2. Adjust:
9 Brake pedal height
Pedal height adjustment steps:
9 Loosen the locknut 1.
9 Turn the adjusting nut 2 until the pedal
height a is within specified height.
9 Tighten the locknut.
w
9 Adjust the pedal height between the
maximum Å Å and the minimum ı ı as
shown. (In this adjustment the bolt 3 3
end b b should protrude out of the lower
adjusting nut 4 4 but not be less than 2
mm (0.08 in) c c away from the brake ped-
al 5 5 ).
9 After the pedal height adjustment, make
sure that the rear brake does not drag.
EC365080
FRONT BRAKE PAD INSPECTION AND
REPLACEMENT
1. Inspect:
9 Brake pad thickness
Out of specification
4.4 mm (0.17 in)
2. Replace:
9 Brake pad
Brake pad replacement steps:
9 Remove the pad pin plug 1.
3-19
INSP
ADJ
Brake pedal height a a :
5 mm (0.20 in)
a
Replace as a set.
Brake pad thickness a a :
Standard
1.0 mm (0.04 in)
<Limit>