Yamaha YZ125N1 Service Manual page 47

1 Brake hose holder
2 Master cylinder
3 Brake hose
4 Hose guide
5 CDI unit band
6 CDI unit
7 High tension cord
8 Ignition coil
9 Cable guide
0 Radiator breather hose
q Wireharness
w "ENGINE STOP" button lead
e CDI magneto lead
r Clutch cable
t Clamp
y CDI unit bracket
u Engine bracket
i CDI unit damper
A Pass the brake hose into
the brake hose holder.
CABLE ROUTING DIAGRAM
B If the brake hose contacts
the spring (rear shock
absorber), correct its twist.
C Install the brake hose so that
its pipe portion directs as
shown and lightly touches
the projection on the master
cylinder.
D Pass the reservoir hose
between the brake hose and
swingarm bracket.
E Put the CDI unit fully in
the CDI unit band.
F Fasten the ground lead
together with the ignition
coil.
G Pass the cluch cable into
the cable guide.
H Clamp the CDI magneto lead
on the upper part of
the frame gusset at its
protecting tube.
2-14
SPEC
I Pass the clutch cable over
the radiator hose.
J Clamp the wireharness on
the top of the CDI unit with
the clamp end downward.
K Cut the clamp end to be flush
with CDI unit side.
L Fit the CDI unit band over
the CDI unit bracket till it
stops.
M Install the brake hose to
the caliper with the paint on
the pipe facing the caliper
and with the pipe contacting
the caliper projection.
N Pass the radiator breather
hose between the frame and
radiator hose so that it is not
kinked or wedged.
O Position the CDI unit between
the engine brackets as
shown.