1: Mix Outputs Setup - SoundCraft Si impact User Manual

CHANNELS & BUSSES > MIX OUTPUTS > SETUP
There are various Mix Output-specific options, found via the Touch Screen Main Menu OUTPUTS button.
These offer channel naming, isolate, LR / LCR panning and routing Pre/Post routing options, width (stereo/
mono) and physical output patching.
Name
Name the selected Mix Bus.
When the Name field is selected, a QWERTY keyboard will appear on the Touch Screen so you can enter the desired
name.
Isolate
Isolate the Mix Bus Master Channel from automation playback.
When a new cue is loaded, this channel will not be affected and its setting will not be changed. However, current
channel settings are still stored when a cue is stored.
Mix Width
Select Mono or Stereo width for this Mix Bus.
Note, only Mix busses 7-14 can be switched to stereo. Mix busses 1-8 are mono only.
Pan Mode
Set Pan mode for this channel to LR (Left Right) or LCR (Left Centre Right).
Routing/Panning for the Main Mix Bus. In LCR mode the Main Mono Mix Bus is used as the Centre channel. Mono
routing must be enabled in the ACS (Assignable Channel Strip) OUTPUT section for this to work.
User Manual
6.2.1: CHANNELS & BUSSES > MIX OUTPUTS > OUTPUTS SETUP

6.2.1: MIX OUTPUTS SETUP