Desa VVSR18 Owner's Operation And Installation Manual page 9

INSTALLATION
Continued
HEARTH KIT ASSEMBLY AND
INSTALLATION
Kit Assembly - Single and Dual-Flame
Only
1. Determine which side the gas line will be coming
into the fireplace.
NOTICE: Triple-burner models
CBL18/24 or BFLT18/24 come
preassembled with gas inlet
on right side of burner pan.
DO NOT attempt to reposition
burner on triple-burner models.
If your fireplace supply is on
the left side, a longer 3/8" flex
line should be purchased and
routed behind burner pan and
away from flame area.
2. Using a hammer and screw driver, remove
knockout plug from the side of the pan that
corresponds to the gas line (see Figure 6).
3. Unscrew burner inlet fitting from burner
manifold.
4. Place burner manifold in pan with threaded
opening facing open knockout plug.
5. Using thread sealant (resistant to the action
of propane/LP gas) on larger end of fitting,
screw the burner inlet fitting through hole and
into burner manifold (see Figure 6). Tighten
using a wrench. If using propane/LP gas, see
Propane/LP Gas Conversion, page 11.
6. Using burner clamp, screw, and nut provided,
assemble clamp to pan ("U" style and triple
burners only). This will hold the burner mani-
fold in place.
7. If using optional GA9050A kit, go to Optional
GA9050A On/Off Safety Valve/Pilot Kit , page
10, for installation instructions. If using option-
al GA9150A kit, follow instructions included
with kit for installation and operation.
901265-01P www.desatech.com
Burner Inlet
Fitting
Screw
Burner Inlet
Fitting
9