Desa VVSR18 Owner's Operation And Installation Manual page 11

INSTALLATION
Continued
6. Install the gas connector tube to the gas supply
fitting. Carefully shape tube to attach to adapter
fitting. Be careful not to cause kinks in tube.
7. Test for leaks following instructions under
Testing Burner for Leaks, page 12.
8. Retighten and adjust the location of the gas
control as necessary. The gas control should be
level, with the control rod to the front.
9. Install cover to burner pan using screws
provided.
10. Install thermocouple, pilot, and ignitor onto
valve cover as shown in Figure 11. Use the
provided screws.
11. Push the control rod extension onto the "D"
shaped control rod through the center hole in
the cover.
12. Install the position decal and control knob
making sure to align the marks with the cor-
rect stop positions of the gas control. Pilot
position will allow the knob to push in about
1/2". Align the decals in the pilot position.
Screw
Ignitor
Control Rod
Control
Extension
Knob
Figure 11 - Installing Cover, Control
Knob, and Piezo Ignitor
901265-01P
Thermocouple
Pilot
Valve Cover
Piezo Ignitor
www.desatech.com 11