Presetting For Mounting The Isofix Child Restraint System - Fiat Bravo Owner's Handbook Manual

PRESETTING
FOR MOUNTING
THE ISOFIX CHILD
RESTRAINT SYSTEM
This car is preset for mounting the Uni-
versal Isofix child restraint system, a new
European standardised system for carry-
ing children safely.
It is possible to mount at the same time
both the traditional restraint system and
the Isofix one.
Fig. 12 shows a child's seat by way of ex-
ample. The Universal Isofix child's seat
covers weight group: 1.
Other weight groups are covered by a
specific Isofix child seat that can be used
only if specifically designed, tested and ap-
proved for his vehicle (see the list of ve-
hicles accompanying the child seat).
Due to its different anchoring system, the
Universal Isofix child's seat shall be an-
chored to the proper lower metal rings
A-fig. 13, set between rear seat back and
cushion. The upper belt (provided with
the child's seat) shall be then secured to
ring B-fig. 14 set at the back of the seat
backrest at child's seat height.
122
fig. 12
Remember that in case of Universal Isofix
child's seat, you can only use all those
seats approved with the marking ECE
R44/03 Isofix.
The Universal Isofix "Duo Plus" child seat
and the special "G 0/1" seat are available
from Lineaccessori Fiat.
For any further details on installation/use,
refer to the "Instruction Manual" for the
child seat.
fig. 13
F0Q0614m fig. 14
WARNING
Mount the child restraint
system only with the car sta-
tionary. The Isofix child restraint sys-
tem is properly anchored to the
mounting brackets when clicks are
heard. In any case, keep to the in-
stallation instructions that must be
provided by the child restraint system
Manufacturer.
F0Q0698m
F0Q0699m