Fiat Bravo Owner's Handbook Manual page 168

fig. 14
❒ make sure the compressor switch
E-fig. 15 is set to 0 (off), start the en-
gine and fit plug D-fig. 14 into the cig-
ar lighter outlet and then turn on the
compressor by setting switch E-fig. 15
to I (on). Inflate the tyre to the pres-
sure specified in paragraph "Cold tyre
inflation pressure" in section "Techni-
cal specifications". Check tyre pressure
on gauge F-fig. 15 with compressor off
to obtain precise reading;
F0Q0515m fig. 15
❒ If after 5 minutes it is still impossible
to reach at least 1.5 bar, disengage com-
pressor from valve and current outlet,
then move the car forth for approx. ten
metres in order to distribute the seal-
ing fluid inside the tyre evenly, then re-
peat the inflation operation;
❒ If after this operation it is still impossi-
ble after 5 minutes to reach at least 1.8
bar, do not start driving since the tyre
is excessively damaged and the quick
tyre repair kit cannot guarantee suit-
able sealing, contact Fiat Dealership;
❒ If reaching the tyre pressure specified
in paragraph "Cold tyre inflation pres-
sure" in section "Technical specifica-
tions", start driving immediately;
F0Q0516m fig. 15a
WARNING
Apply the sticker in a visible
position for the driver to in-
dicate that the tyre has been treat-
ed with the quick tyre repair kit. Dri-
ve carefully especially when corner-
ing. Do not exceed 80 km/h. Avoid
heavy braking and accelerating.
❒ after driving for about 10 minutes stop
and check again the tyre pressure; pull
up the handbrake;
F0Q0017m
167