Table of Contents
Advertisement
TG5511-6511-6512CX(e-e).book Page 37 Tuesday, May 11, 2010 11:46 AM
Caller ID
Problem
Caller information is not
displayed.
Caller information is slow to
display.
Time on the unit has shifted.
The name stored in the
phonebook is not fully
displayed while an outside call
is being received.
Liquid damage
Problem
Liquid or other form of moisture
has entered the handset/base
unit.
Caution:
L To avoid permanent damage, do not use a microwave oven to speed up the drying
process.
Useful Information
Cause/solution
L You must subscribe to a Caller ID service.
Contact your service provider/telephone
company for details.
L If your unit is connected to any additional
telephone equipment, remove and plug the
unit directly into the wall jack.
L If you use a DSL/ADSL service, we
recommend connecting a DSL/ADSL filter
between the base unit and the telephone line
jack. Contact your DSL/ADSL provider for
details.
L Other telephone equipment may be interfering
with this unit. Disconnect the other equipment
and try again.
L Depending on your service provider/
telephone company, the unit may display the
caller's information at the 2nd ring or later.
L Move closer to the base unit.
L Incorrect time information from incoming
Caller ID changes the time. Set the time
adjustment to "Manual" (off) (page 21).
L Edit the phonebook entry name to fit in 1 line
of text (page 18).
Cause/solution
L Disconnect the AC adaptor and telephone line
cord from the base unit. Remove the batteries
from the handset and leave to dry for at least
3 days. After the handset/base unit are
completely dry, reconnect the AC adaptor and
telephone line cord. Insert the batteries and
charge fully before use. If the unit does not
work properly, contact an authorised service
centre.
37
Advertisement
Table of Contents
