TG5511-6511-6512CX(e-e).book Page 35 Tuesday, May 11, 2010 11:46 AM
Problem
I cannot register a handset to a
base unit.
Battery recharge
Problem
The handset beeps and/or )
flashes.
I fully charged the batteries, but
– ) still flashes or
– the operating time seems to
be shorter.
The handset display is blank.
Making/answering calls, intercom
Problem
_ is displayed.
Useful Information
Cause/solution
L The maximum number of handsets (6) is
already registered to the base unit. Cancel
unused handset registrations from the base
unit (page 25).
L You entered the wrong PIN. If you forget your
PIN, contact an authorised service centre.
Cause/solution
L Battery charge is low. Fully charge the
batteries (page 9).
L Clean the battery ends (S, T) and the
charge contacts with a dry cloth and charge
again.
L It is time to replace the batteries (page 9).
L The handset is not turned on. Turn the power
on (page 13).
Cause/solution
L The handset is too far from the base unit.
Move closer.
L The base unit's AC adaptor is not properly
connected. Reconnect AC adaptor to the
base unit.
L The handset is not registered to the base unit.
Register it (page 25).
L Activating one touch eco mode reduces the
range of the base unit in standby mode. If
required, turn eco mode off (page 14).
35