Air Filter; Control Box Assembly; Light Fixture - Electrolux E32AR75FPS Technical & Service Manual

Component Teardown
Air Filter Removal
Push the plastic bubble tab at the back of the control
box housing. This releases the hinged bottom half to
drop open. Remove the old filter and discard it.
Unpackage the new filter and place it inside the hinged
bottom half of the housing. Push the hinged bottom half
upward until the tab snaps into closed position.
(See Figure 6-12)
Control Box Assembly Removal
The control box assembly is secured with fi ve screws to
the top of the refrigerated compartment and has sealant
along the front face to prevent ambient air from reaching
the compartment thermistor.
The water fi lter components are part of the control box
assembly.
To remove the control box:
1. Disconnect power from unit.
2. Remove the adjustable shelves.
3. Extract the five screws from the recessed holes
in control box securing the control box to the
compartment ceiling. (See Figure 6-13)
4. Pull forward on the control box until the sealant
along the front edge breaks. Use caution not to
strain the wire harness connections.
5. Disconnect wire harness from control box at the
quick disconnects.
6. Push in on the outer edges of the fittings connecting
the water filter base to the inlet and outlet water lines
as you pull the water lines out of water filter base.
Control box is now free.
Light Fixture Removal
To remove the light fixture:
1. Disconnect power from unit.
2. Remove control box from refrigerated compartment.
3. Remove light bulbs by turning counter-clockwise.
4. Disconnect wire leads from light fixture terminals.
5. Press on the retaining latches securing the light
fixture to the control box while pushing the light
fixture through the cutout in the control box. (See
Figure 6-14)
Figure 6-12. Light Shield and Fixture Removal
Screws
Figure 6-13. Control Box Removal
Control Box
Figure 6-14. Light Fixture Removal
6-6
Screws
Light
Fixture