Care & Cleaning Of Your Trim Kit; Door Removal; Door Handle Mounting Instructions - Electrolux E32AR75FPS Technical & Service Manual

Care & Cleaning Of Your Trim Kit
The trim and grill kit surfaces are best cleaned with a
cotton cloth dampened with a mixture of water and mild
detergent. Avoid using abrasive cleaners as they will
mar the surface of the metal components.

Door Removal

For some installations it may be necessary to remove the
door to fi t through the entrance of the installation site.
To remove the door, follow the steps below.
1. Make sure electrical plug is disconnected from the
wall outlet.
2. Gently lay freezer on its back on a soft clean
surface.
3. Remove kickplate.
4. Lift plastic cover off upper hinge assembly.
(See Figure 2-29)
5. Using a 3/8" socket or wrench, extract the two bolts
securing the upper hinge to the unit frame.
6. Using a 3/8" socket or wrench, extract the two bolts
securing the lower hinge to the unit frame. Use a
phillips head screwdriver to extract the remaining
screw from the lower hinge assembly.
(See Figure 2-30).
7. Lift the door assembly off of the unit frame.
Door Handle Mounting
Instructions
For some installations the door handle may need to be
removed. (See Figure 2-31)
To remove the door handle:
1. Remove screw cover plates by pushing in and
sliding the screw cover plate off of the door handle.
2. Using a phillips head screwdriver, extract the screws
securing the door handle to the door assembly.
3. Push upwards until the screw button assembly is
free of the dovetail inside the handle assembly. Pull
handle assembly from door.
Installation Information
Figure 2-29. Top Hinge Removal
Figure 2-30. Bottom Hinge Removal
Figure 2-31. Handle Removal
2-15
Hinge Cover
3/8" Bolts
Hinge Plate
Set Screws