Electrical Information - Electrolux E32AR75FPS Technical & Service Manual

Installation Information
Leveling Instructions For All
Refrigerator/Freezer Pairs
• Remove two leg levelers provided in literature bag.
While unit is lying on its back for wood skid removal,
install both leg levelers in rear of unit.
• Level door of first unit using all four levelers and
slide unit into place. Recheck for levelness and
adjust if necessary.
• Measure distance from floor to bottom of door on
first unit. Adjust and level second unit so door height
matches.
• Leg Level Adjustments:
• One full turn of all four leg levelers will raise door
5/32".
• One full turn of both front leg levelers will raise door
3/16" and tilt top of door back 7/16".
• One full turn of both rear leg levelers will lower door
1/32" and tilt top of door forward 7/16".
• One full turn of both side leg levelers will raise door
3/16" and tilt top of door 3/8".
• Slide second unit into place leaving a minimum gap
of 3/16" between units for door swing clearance.
• This last step may require at least one extraction of
the second unit to properly align units in a "built-in"
application.

Electrical Information

These guidelines must be followed to ensure that safety
mechanisms in the design of the unit will operate
properly.
Refer to the serial plate for correct electrical rating. The
power cord of the unit is equipped with at three-prong
grounding plug for protection against shock hazards. It
must be plugged directly in to its own properly grounded
three-prong receptacle, protected with a 15 amp time
delay fuse or circuit breaker. The receptacle must be
installed in accordance with the current edition of the
National Electrical Code (NFPA 70) the local codes and
ordinances. Consult a qualifi ed electrician. Receptacles
with Ground Fault Circuit Interrupters (GFCI) are NOT
RECOMMENDED. DO NOT USE AN EXTENSION
CORD OR AN ADAPTER PLUG.
If the voltage varies by 10% or more, freezer and/or
refrigerator performance may be affected. Operating any
unit with insuffi cient power can damage the motor. Such
damage is not covered under the warranty. If you suspect
your voltage is high or low, consult your power company
for testing.
To prevent the freezer from being turned off accidentally,
do not plug the unit in to an outlet controlled by a wall
switch or pull cord. Do not pinch, knot, or bend the power
cord in any manner.
Avoid fire hazard or electric shock. Do not use an
extension cord or an adapter plug. Do not remove
any prong from the power cord.
Figure 2-3. Electrical Receptacle
Never unplug the freezer by pulling on the power
cord. Always grip the plug firmly and pull straight
out from the receptacle.
Turning the control to "OFF" turns off the
compressor but does not disconnect power to
other electrical components.
2-4