Chassis Tightening Torques - Yamaha 2006 YSF-R1(V) Supplementary Service Manual

CHASSIS TIGHTENING TORQUES

Horn bracket and under bracket
Connecting rod (YZF-R1S)
Side cover and fuel tank
Front fork and stay (YZF-R1S)
Front fork and bracket (YZF-R1S)
Rear brake master cylinder and foot rest bracket
Front brake disc and front wheel (YZF-R1S)
Front wheel axle pinch bolt (YZF-R1S)
Cap bolt (YZF-R1S)
Cap bolt and lock nut (YZF-R1S)
Damper rod assembly (YZF-R1S)
Item
TIGHTENING TORQUES
Tightening
Thread
size
Nm
M6 7
M6 8
M5 4
M5 6
M5 6
M6 13
M6 23
M8 26
– 20
M12 25
– 48
NOTE: NOTE:
1. Insert the front wheel axle from the right
side and tighten it with the flange bolt from
the left side to 91 Nm (9.1 m•kg, 65.8 ft•lb).
2. In the order from the pinch bolt
→ pinch bolt
bolt
26 Nm (2.6 m•kg, 19 ft•lb) without perform-
ing temporary tightening.
3. Check that the end face of the axle head
and the end face of the fork side are flush-
mounted. If they are out of alignment, make
sure to fit them by adding the external force
by hand or with a plastic hammer, etc.
If the end face of the axle is not parallel to
the end face of the fork, align them so that
one point of the axle circumference is posi-
tioned on the end face of the fork.
At this stage, it can be accepted if the end
face of the axle becomes partially concave
to the end face of the fork.
4. In the order from the pinch bolt
→ pinch bolt
bolt
26 Nm (2.6 m•kg, 19 ft•lb) without perform-
ing temporary tightening.
9
SPEC
Remarks
m•kg ft•lb
0.7 5.1
0.8 5.8
0.4 2.9
0.6 4.3
0.6 4.3
1.3 9.4
2.3 17
2.6 19 See NOTE
2.0 14
2.5 18
4.8 35
, tighten each bolt to
, tighten each bolt to
→ pinch
→ pinch