Yamaha 2006 YSF-R1(V) Supplementary Service Manual page 83

CLUTCH
10.Install:
• pull lever
NOTE: NOTE:
Install the pull lever with the " " mark facing
toward upper side.
11.Install:
• clutch cover
• clutch cover gasket
NOTE: NOTE:
• Install the pull rod so that the teeth a face
towards the rear of the vehicle. Then, install
the clutch cover.
• Apply oil onto the bearing.
• Apply molybdenum disulfide grease onto the
pull rod.
• When installing the clutch cover, push the pull
lever and check that the punch mark
the pull lever aligns with the mark
clutch cover. Make sure that the pull rod teeth
and pull lever shaft pinion gear are engaged.
12.Tighten:
• clutch cover bolts
• clutch cover bolt
NOTE: NOTE:
Tighten the clutch cover bolts in a stages and
in a crisscross pattern.
13.Adjust:
• clutch cable free play
Refer to "ADJUSTING THE CLUTCH
CABLE FREE PLAY" in chapter 3.
75
ENG
on the
12 Nm (1.2 m•kg, 8.7 ft•lb)
12 Nm (1.2 m•kg, 8.7 ft•lb)
®
LOCTITE
on