Table of Contents
Advertisement
User manual: Pro-700RGB
Keep surrounding dry and clean.
or damp and dusty environment. Projector should be put in a water-proof housing
when operated outside.
Operating temperature is 10~35° C . Let laser cool off 10minutes after 2 hours of
operation, to ensure maximum lifetime for the diode.
Distance between laser aperture and projection screen should be not less than 1
meter.
Do not turn device on and immediately off again frequently.
Do not look into the laser beam directly, especially not with optical instruments.
Do not touch the device with wet hands.
When the laser diode becomes dim or broken, please contact your dealer timely.
When returning laser to dealer/manufacturer always use original packaging.
Maintenance should be performed every 15-day period. Use a sponge with alcohol,
rather than wet cloth or other chemical liquid, to clean the mirror.
Using the laser
Make sure the correct voltage is used. Connect mains. Connect an emergency switch
to the 9-pin connector on the backside (pins 1, 2). If you do not wish to connect an
emergency switch, connect the 9-pin plug. Depending on the mode selected (see
below), laser light should come out of the
opening on the front panel – be careful.
1
Security switch: Laser on/off
2
Remote lock: connect emergency switch. If no
emergency switch is connected use the 9 pin plug
supplied.
3
DMX In/Out: DMX512-Standard signal
4
Power switch: power on/off
5
Power: connect to mains. Make sure the correct
voltage is used
6
ILDA connector in/out
Control Panel
•
MODE: select mode, or go up in menu
•
ENTER: confirm changes, or go down in menu
•
UP/ DOWN: change DMX address
Operating modes:
Test mode: a built-in test pattern is displayed
"DMXAddr": DMX512 mode-. Here you can change the DMX
address:
"Open": change address
"Up" & "down": increase/decrease address
"Save": save new address
This unit should be kept dry, do not use in the rain
Page 4 of 9
Rev: 01/2009
Advertisement
Table of Contents
