To Replace The Mains Plug - Sharp R-371 Operation Manual

TO REPLACE THE MAINS PLUG

The wires in the mains cable are colour coded as
shown:
Green and yellow stripes
Blue
Brown
As the colours in the mains lead of your oven
may not correspond with the coloured marking
identifying the terminals in your plug, connect the
wires as described:
The green and yellow wire to the plug terminal
marked E or or coloured green or
coloured green and yellow.
The blue wire to the plug terminal marked N
or coloured black or coloured blue.
The brown wire to the plug terminal marked L
or coloured red or coloured brown.
If you are unable to resolve a problem using
the checks covered on the last few pages, do
not attempt to service this microwave
oven yourself.
Contact the dealer or supplier from whom the
oven was purchased in order to obtain service.
Where this is not possible, please contact the
SHARP Customer Information Centre.
Telephone: 0845 888 8112 (office hours).
R-371
= EARTH
= NEUTRAL
= LIVE
CALLING FOR SERVICE
Make sure the terminal screws are tight and the
cable is held securely by the cable grip where it
enters the plug.
Like most appliances in your home, your oven
must be connected to a single phase 230-240V,
50Hz alternating current supply.
If you do not make the proper electrical
connections you might damage the oven or injure
yourself. Neither SHARP nor the supplier will be
liable if this happens.
WARNING: THIS APPLIANCE
MUST BE EARTHED
If you have any doubts about your
electrical supply ask a qualified
electrician.
For general information and assistance with
oven queries, please contact our
Customer Information Centre:
U.K.: 0845 888 8112 (office hours)
Ireland: 01 676 0648 (office hours)
Website: http://www.sharp.co.uk/support
Replacement accessories may be obtained
from our main parts distributor:
Willow Vale Electronics Ltd.
Telephone: 0121 766 5414
24
11/20/2010