Pride Mobility Victory ES9 Owner's Manual page 32

V I . C O M F O R T A D J U S T M E N T S
POSITIONING BELT
Your scooter seat may be equipped with an auto-type
positioning belt that can be adjusted for operator
comfort. The positioning belt is designed to help sup-
port the operator so that he or she does not slide down
or forward in the seat. The positioning belt is not
designed for use as a restraining device.
To install the positioning belt (if required):
1. Remove the seat from your scooter.
2. Place the seat upside down so that you can see the
bottom of the seat base. See figure 19.
3. Use a wrench to remove the two rear bolts that
attach the seat frame to the seat base.
4. Insert the bolt through the appropriate ends of the
positioning belt and then reinstall the bolts back
into the seat base.
5. Tighten the bolts.
To adjust the positioning belt for operator comfort:
1. Insert the metal tab on the right side of the belt
into the plastic housing on the opposite strap until
you hear a "click." See figure 20.
2. Pull the strap on the right side of the belt until it is
secure, but not so tight as to cause discomfort.
To release the positioning belt:
1. Press the push button mechanism on the plastic
housing.
MANDATORY! Make sure the posi-
tioning belt is properly secured to
the scooter and is adjusted for oper-
ator comfort before each use.
MANDATORY! Inspect the position-
ing belt for loose or damaged parts
before each use of the scooter. If you
discover a problem, contact your
authorized Pride Provider for mainte-
nance and repair.
32
Figure 19. Positiong Belt Illustration
Figure 20. Positioning Belt
www.pridemobility.com
REAR
BOLTS
Victory ES Series