Host Station (Transmitter) Configuration - Kenwood TS-480HX Setting Manual

3.3. Host Station (Transmitter) Configuration

Transceiver
TS-480
Transceiver TS-480
Connection RS-232C
Audio
PC Specifications
Sound function To exchange audio transmissions, a sound function is
RS-232C
(Transceiver control)
Audio transmission
The TS-480 transceiver is supported. The ARCP-480 and
ARHP-10 are specialized for the TS-480, thus other
transceivers cannot be used to configure the system.
Controls that change the frequency or mode are
performed by connecting the transceiver and PC using an
RS-232C cable. (The transceiver has only one RS-232C
connector (COM connector), so if you are using the
RS-232C connector (COM connector) for KNS operations,
another device cannot be connected.)
The audio cable is created by the customer.
To exchange audio transmissions, connect the transceiver
DATA connector to the PC sound I/O terminal. For the
transceiver connector specifications, refer to the TS-480
instruction manual, and for the cable creation and
connection methods, refer to
Cable".
CPU and memory:
Minimum values recommended by the operating system.
HDD:
To install both the ARHP-10 and the ARVP-10, a minimum
of approx. 100 MB of free disk space is required. If saving
connection logs, additional memory space is required.
required.
Sound Blaster 16 or higher is recommended.
For the sound functions in comprehensive chipsets, the
sound transmission may not be exchanged normally in
some cases.
5
PC
ARHP-10
ARVP-10H
Sound function
"4.2. Connecting an Audio
LAN/WAN