Host Station (Transmitter) Configuration - Kenwood TS-590SG Setting Manual

3.3. Host Station (Transmitter) Configuration

Transceiver TS-590SG
Connection USB
or
RS-232C
Audio
PC Specifications
Sound function To exchange audio transmissions, a sound function is
Network
function
The TS-590SG transceiver is supported. The ARCP-590G
and ARHP-590G are specialized for the TS-590SG, thus
other transceivers cannot be used to configure the system.
Controls that change the frequency or mode are
performed by connecting the transceiver and PC using
either a USB cable or RS-232C cable. (The transceiver
has only one RS-232C connector, so if you are using the
RS-232C connector for KNS operations, another device
cannot be connected.)
The audio cable is created by the customer.
To exchange audio transmissions, connect the transceiver
ACC2 connector to the PC sound I/O terminal. For the
transceiver connector specifications, refer to the
TS-590SG instruction manual, and for the cable creation
and connection methods, refer to
Audio Cable".
CPU and memory:
Minimum values recommended by the operating system.
HDD:
To install both the ARHP-590G and the ARVP-10, a
minimum of approx. 100 MB of free disk space is required.
If saving connection logs, additional memory space is
required.
required.
Connects to the home LAN.
To perform KNS operations via the internet, connect to a
network that is connected to the internet.
A wired network is recommended.
5
"4.2. Connecting an