Norvell PRESTIGE 2100 Instruction Manual And Users Manual page 18

US
Malfunction
Atomization too
coarse
Uneven spray
pattern
Excessive overspray
Spray tanning
solution runs down
body
The tan is patchy or
blotchy
Customer's skin
appears orange
System no longer
functions during
use
16
Cause
•
Material volume setting
turned too far clockwise
•
Nozzle contaminated
•
Too little pressure build-up in
container
•
Air filter heavily soiled
•
Amount of air too low
•
Spray tanning solution in the
container is running out
•
Nozzle seal worn
•
Air filter heavily soiled
•
Distance too large
•
Material volume setting
turned too far clockwise
•
Amount of air too high
•
Too much spray tanning
solution applied
•
Spray paths overlap too much
•
Spraying distance too small or
spray movement too slow
•
Skin was not correctly
prepared
•
Spray movement not even
enough
•
Too much spray tanning
lotion applied
•
Skin was not correctly
prepared
•
High sensitivity to active
ingredient DHA
•
System overheated
PRESTIGE 2100
Remedy
➞ Turn material volume
setting anticlockwise
➞ Clean
➞ Tighten container
➞ Replace
➞ Increase air volume
➞ Refill
➞ Replace
➞ Replace
➞ Reduce distance
➞ Turn material volume
setting anticlockwise
➞ Reduce air volume
➞ Carefully dab affected
points with a towel,
reduce flow setting if
required and lightly
overspray again
➞ Correct by lightly
overspraying
➞ Remove spray tanning
lotion from the skin.
Prepare skin correctly for
new application, reduce
flow setting
➞ Use another shade with
lower concentration of
DHA
➞ Unplug the power plug,
let the system cool down
approx. 30 minutes, do not
bend the hose, check the
air filter, do not cover the
intake slots