Working Mode - TP-Link TL-WR802N User Manual

You will see the following screen when the new device has successfully connected to the network.

Note:
1. The WPS LED on the AP will light green for five minutes if the device has been successfully
added to the network.
2. The WPS function cannot be configured if the Wireless function of the AP is disabled. Please
make sure the Wireless function is enabled before configuring the WPS.

4.5 Working Mode

The Router supports five operation mode types: Wireless Router, Access Point, Repeater,
Client and Wireless Client Router. Please select one you want. Click Save to save your choice,
which is shown as Figure 4-7.
Standard Wireless Router - The wireless Router Mode. In this mode, the device enables

multi-user to share Internet via DSL/Cable Modem. The only wired port works as WAN.
Access Point - The wireless access point mode.

Repeater - The wireless Repeater Mode. It could extend the range of wireless network.

Client - The Client Mode. The computer connected by Ethernet could get access to an AP by

Client mode.
TL-WR802N
Figure 4-6
Figure 4-7 Wireless Working Mode Settings
- 36 -
300Mbps Wireless N Nano Router