Panasonic WV-CZ362E Operating Instructions Manual page 11

8 Motion Detector Setting (MOTION DET)
1. Select ON or OFF.
2. If ON is selected, press the setting button. The MOTION DETECT menu appears.
You can mask the areas in this menu.
3. Move the cursor to MASK SET and press the setting button. 48 mask areas appear
on the monitor screen.
Refer to Light Control Setting on page 8 for masking operations.
4. After masking areas, press the setting button more than 2 seconds. The MOTION
DETECT menu appears on the monitor screen.
5. Move the cursor to ALARM and select ON or OFF.
ON: The alarm signal is supplied while the display mode is activated.
OFF: The alarm signal is not supplied while the display mode is activated.
6. Move the cursor to DISPLAY MODE.
Press the setting button to see the present setting. The areas that detect the motions
blink.
7. Move the cursor to LEVEL.
Obtain the optimum detection level.
8. Dwell Time
Move the cursor to DWELL TIME, and select a time. When the time specified here elaps-
es after motion detection, the camera will notify the connected device of the alarm acti-
vation.
Selectable times (seconds): 2 s, 5 s, 10 s, 30 s.
Important Notices:
Motion detection should meet the following conditions.
1) The picture size on the screen should be larger than 1/48 of the actual picture size.
2) The contrast ratio between the object and the background picture should be more
than 5% at the maximum detection level.
3) The time that takes the object to move from one end of the screen to the other
should be more than 0.1 second.
Also under the following conditions, mask or adjust the detection level to prevent mal-
function.
1) When leaves, curtains, etc. are swayed by the wind.
2) When a picture has a high noise content due to low light conditions.
3) When the object is illuminated by lighting equipment that constantly turns on and
off.
** MOTION DET **
LEVEL ••••|••••
- +
DWELL TIME 2S
DISPLAY MODE
ALARM OFF
MASK SET
RET TOP END
11