Panasonic WV-CZ362E Operating Instructions Manual page 10

5 Electronic Sensitivity Enhancement (SENS UP)
The electronic sensitivity enhancement mode changes as follows:
While the SENS UP function is selected, noise or spots may appear in the picture when
the sensitivity of the camera is increased. This is a normal phenomenon.
6 Synchronization Setting (SYNC)
The priorities of SYNC modes are assigned as follows:
1. Multiplexed vertical drive (VD2)
2. Internal sync (INT)
Note: Whenever the vertical drive pulse (VD2) is supplied to the camera, the camera sync
mode is automatically switched to the multiplexed vertical drive pulse (VD2) regard-
less of the selected sync mode.
7 White Balance Setting (WHITE BAL)
1. Auto-Tracing White Balance Mode (ATW1/ ATW2)
The range of color temperature is
* ATW2 is suited to setting when a sodium lamp is used.
(1) The white balance of the camera is automatically adjusted at ATW1 and ATW2.
(2) For fine adjustment of ATW1/ATW2, press the setting button. The ATW1/ATW2 fine
adjustment menu appears on the monitor screen.
2. Automatic White Balance Control Mode (AWC)
In this mode, the supported color temperature range is approximately 2 500K to 8 000K.
This mode is best in location where the light source is constant.
(1) Select AWC n PUSH SET.
(2) Press the setting button to start the white balance setup. PUSH SET is highlighted to
indicate that white balance is being set.
(3) PUSH SET returns to normal when balance setting is completed.
(4) For fine adjustment of the AWC, move the cursor to AWC and press the setting but-
ton. The AWC fine adjustment menu appears on the monitor screen.
10
OFF X2 AUTO X4 AUTO
X16 AUTO X32 AUTO
X6 FIX X10 FIX X16 FIX
ATW1 2 600 K-6 000 K
ATW2 2 000 K-6 000 K
** ATW1 **
R
B
RET TOP END
**
R
B
RET TOP END
X6 AUTO X10 AUTO
OFF X2 FIX X4 FIX
X32 FIX
••••|••••
- +
••••|••••
- +
AWC **
••••|••••
- +
••••|••••
- +