THUNDER TIGER TTR4571 Assembly Manual page 14

TAIL GEAR SECTION
40.
Glue the tail gear mount and secure the mount on the tail
with four 2x8mm washer wood screws.
41.
Locate the tail gear bag, and assemble the tail gear as
shown. Secure the tail gear assembly on the tail gear
mount with 4x20mm Flat Head machine Screws.
42.
Locate the straight threaded end, brass tube, M2 nuts,
clevises and cable. First thread the M2 nut and clevis then
secure the M2 nut on clevis. Then route the cable through
the tube and make it a circle.
43.
Next slide the cable through the threaded end then slide
to the tube again.
44.
Make the other circle as shown.
45.
Adjust the cable to make the circle as small as possible
then use the pliers to crimp the cable firmly.
46.
Use masking tape to tape the cable on the servo tray,
thread the other end with clevis through the fuselage and
snap the clevis onto the steering arm.
14