THUNDER TIGER TTR4571 Assembly Manual page 10

FUSELAGE
19.
Glue the fuselage center bulkhead in place. It will be
better to lightly sand the glue area then apply Epoxy or
thick CA and position it just tight to the fuselage. Do not
ever push it far enough back as it may damage the fuselage.
20.
Place the side frame assembly into the fuselage. Go rear
first then slide the side frame assembly into the front
fuselage. Finally slide the side frame assembly through the
front bulkhead as shown. Make sure the notch is just right
out of the firewall. Glue the side frame on front bulkhead
with epoxy.
L
R
L
R
21.
Glue the side frames on middle bulkhead with thick CA or
epoxy.
22.
Sandwich the three firewalls together; note the cross laser
cut mark should be on the top and smallest one at the
bottom. Epoxy the firewall and reinforced plywood piece
on the side-frame and make sure the throttle pushrod hole
is at the bottom. It might need to bend the side frame and
push the firewall in place.
23.
Epoxy the battery box; first glue the bottom of the box,
then the two sides. Note the two box sides should reach
the very front end of the bottom of the box.
10