Electrical Connection; Operation; Maintenance; Guarantee - Hyco SpeedFlow sf10l Installation & Operating Instructions

4. ELECTRICAL CONNECTION

Installation should comply with the latest IEE regulations,
Connection should be to a fused switched 13A spur. If the cable length is insufficient, it is recommended
that the entire cable is replaced and no joins made to the original.
THE SPEEDFLOW MUST BE EARTHED.
IMPORTANT:

5. OPERATION

Switch on the mains supply. The external neon lamp indicates when the element is heating. The
adjustable thermostat has a range of 20-70 degrees centigrade.
A re-settable safety cut-out switches off the electricity supply in the event
of the element over-heating. To access the cut-out, unscrew the grey
plastic cover plate. The cut-out is identified by a small red button and is
located inside the centre of a white disc. To re-set the cut-out, press the
red button.
If the Speedflow is to be used by children or the elderly, a thermostatic mixing valve should be fitted to
limit the maximum water temperature to a safe level.
MAINTENANCE: The anode must be checked annually for signs of corrosion and replaced when
IMPORTANT:
The Speedflow is guaranteed for 12 months against faults in manufacture. Hyco reserves the right to
repair or replace faulty products. Incorrect installation and consequences of limescale deposits are
excluded. Hyco Manufacturing Ltd shall not be liable for any consequential losses.
Version 1.1 Oct 2006
DO NOT SWITCH ON THE HEATER UNLESS YOU ARE CERTAIN THAT IT
IS COMPLETELY FULL OF WATER. FAILURE TO DO SO WILL VOID
THE WARRANTY.
necessary.
DO NOT SWITCH HEATER ON IF IT IS SUSPECTED OF BEING FROZEN.

GUARANTEE