Advertisement
Check all connections are completely water tight. You will need to
use a ½" female to 15mm connectors (not supplied).
This unit has a re-settable thermal cut-out. If the unit is not
heating the water, first check the re-set button.
This unit must be mounted upright with pipe connections at the top.
To reduce operating costs and scale build-up, Hyco recommend the
temperature is set at the lowest acceptable heat level.
Advertisement
Table of Contents
Related Manuals for Hyco SpeedFlow sf10l
Summary of Contents for Hyco SpeedFlow sf10l
- Page 1 This unit has a re-settable thermal cut-out. If the unit is not heating the water, first check the re-set button. This unit must be mounted upright with pipe connections at the top. To reduce operating costs and scale build-up, Hyco recommend the temperature is set at the lowest acceptable heat level.
- Page 2 1. GENERAL The Hyco Speedflow is an unvented water heater designed for direct connection to the mains supply, and can service one or more outlets using ordinary taps. It is also suitable for connection to gravity fed systems. It is recommended that the Speedflow is fitted by an experienced installer familiar with unvented units.
- Page 3 DIAGRAM A – Pressure below 4.2 bar No accessories needed DIAGRAM B – Cold draw off nearby Accessory SF1 needed to prevent expanded warm water entering cold water supply DIAGRAM C – Pressure above 4.2 bar Accessory SF2 needed to prevent pressure relief valve discharging constantly...
- Page 4 DO NOT SWITCH HEATER ON IF IT IS SUSPECTED OF BEING FROZEN. GUARANTEE The Speedflow is guaranteed for 12 months against faults in manufacture. Hyco reserves the right to repair or replace faulty products. Incorrect installation and consequences of limescale deposits are excluded.
Need help?
Do you have a question about the SpeedFlow sf10l and is the answer not in the manual?
Questions and answers