Hammer Strength OHDMR Assembly Instructions Manual page 5

23
Use this set of holes for
assembly with PLATFORM.
FIGURE 2
STEP 2:
• LOOSELY assemble the BOTTOM UPRIGHT SUPPORT (15) to the REAR UPRIGHTS (4) using four 1/2 X 4-1/4" BOLTS (26), four
1/2" PLASITC DOME WASHERS (22), four 1/2" INT TOOTH LOCK WASHERS (20) and four1/2" LOCK NUTS (23) as shown in
FIGURE 2.
• Insert fourteen 9/16" HOLE CAPS (27) into the holes of the REAR UPRIGHTS (4) and the LEFT and RIGHT UPRIGHT BASE (1 & 2)
as shown in FIGURE 2.
4
20
22
26 1/2 X 4-1/4"
4
15
27
5
Use this set of holes for
assembly without PLATFORM.