Winding The Bobbin - Janome 3022 Instruction Book

1
2
5
1
2
3
3
6
4
7
1

Winding the Bobbin

z Pull the handwheel out.
x Draw the thread from spool.
Guide the thread around the bobbin winder
thread guide.
c Insert the thread through the hole in the
bobbin from the inside to the outside.
Put the bobbin on the bobbin winder spindle.
v Push it to the right.
b With the free end of the thread held in your
hand, depress the foot control.
Stop the machine when it has made a few turns,
and cut the thread close to the hole in the
bobbin.
n Depress the foot control again.
When the bobbin is fully wound, stop the
machine.
Return the bobbin winder spindle to its original
position by moving the spindle to the left, and
cut the thread.
m Push the handwheel to the left. (original
position).
Note:
Return the bobbin winder spindle when the
machine stops.
• Inserting bobbin
z Place a bobbin in the bobbin case, making
sure the thread feeds clockwise from the
bobbin.
x Draw the thread through the slot of the case.
c Continue to draw the thread under the tension
spring and through the opening.
Pull out about 4˝ (10 cm) of thread.
q Tension spring
16