JVC HX-GD8 Service Manual page 27

3.2.12 Removing the side (R) assembly
(See Fig.22 to 26)
• Prior to performing the following procedures, remove the tray
assemblies and DVD servo board.
(1) From the inside of the side (R) assembly, release the two
tabs u of the gear cover and remove the gear cover out-
ward. (See Figs.22 and 23.)
(2) From the right side of the DVD changer mechanism as-
sembly, remove the elevator spring attached to the hook v
of the loader assembly. (See Figs.23 and 24.)
(3) From the top side of the DVD changer mechanism assem-
bly, turn the gear 1 clockwise to move the elevator cam
rearward. (See Fig.24.)
(4) Move the two slots w and joint x of the elevator cam and
remove the elevator cam outward. (See Fig.24.)
(5) Remove the three screws V and detaches the side (R) as-
sembly upward. (See Figs.25 and 26.)
Note:
When reattaching the side (R) assembly, make sure to fit the
shaft (part y) into the slot of the select lever. (See Fig.25.)
Side(R) assembly
Side(R) assembly
Gear cover
Elevator cam
Loader assembly
u
Fig.22
Elevator
Gear 1
v
Fig.23
Elevator spring
w x
Fig.24
V
Select lever
y
V
V
Side(R) assembly
Fig.25
V
Side(R) assembly
Fig.26
v
Elevator cam
w
V
(No.MB188)1-27