Advertisement
www.aeroplusrc.com
Test fit the horns
The area on the horns that goes inside the elevator needs to be roughed up with sandpaper. This allows a better glue joint.
Glue the horns in place with epoxy glue. Put a bolt through the ball joint hole to make sure that the horns stay in alignment while drying.
Before fitting the elevator servo fix an extension lead so that the wire can be routed through the cardboard tube wire holder in the fuselage. On the
servo lead joint add a servo plug clip.
Fit the Elevator Servo servo and using a fine drill, drill holes for the servo screws. Remove the servo and drop thin cyno into all 4 holes.
Re‐fit the elevator servo and secure it in with servo screws.
AeroPlus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Advertisement
