Entering Setup; When The Computer Is On - IBM 6266 User Manual

Entering Setup

When the computer is on

Follow these steps to enter Setup when the computer is on:
1. Save all open files, close all applications, shut down the computer, then turn it
off.
2. Turn on the computer and display.
3. When you see the IBM logo and the line message "Press F1 to enter Setup",
press F1 to enter Setup and display the Configuration/Setup Utility menu.
Note:
If you have previously set a power-on password, you are prompted to type in
the password after you press the F1 key. Refer to "System Security" on page
4-15 for information on setting, changing, and removing the password.
4-4 IBM Personal Computer User Guide
You cannot enter Setup after the Power On Self Test
(POST) is complete.