JBL SB300 Quick Start Manual page 5

connectIonS
sOurce cONNectiONs
analog: Use the supplied stereo audio cable to connect the soundbar's
Source 1 (analog) input to your TV's stereo audio output. If your TV has
two sets of audio output jacks, use the set that has a fixed (not variable)
output level. This will let you turn your TV's speakers all the way off
while the TV still supplies a constant audio signal to the soundbar.
digital: If your DVD player, cable tuner or satellite tuner has an optical
digital output, you can use an optical digital audio cable to connect it to
the soundbar's Source 2 (optical digital) input.
sB300 soundbar
tV
AUDIO
OUT
Stereo Audio
Cable (supplied)
OPTICAL
DIGITAL
OUT
NOTE: If your DVD player, cable tuner or satellite tuner does not have an
optical digital output, you can connect its analog audio output to your
TV. The TV will send its audio signal to the soundbar through the analog
connection described above.
POWer cONNectiONs
After verifying that all of the source connections have been made
properly, plug the supplied power cords into the soundbar's and
subwoofer's Power Cord connectors, and plug the other ends into
active, unswitched AC outlets. Do NOT plug these cords into the
accessory outlets found on some audio components.
Power Cord
Optical Digital Audio
Cable (not supplied)
cable/satellite tuner
To Unswitched
AC Qutlet
dVd Player or
www.jbl.com www.jbl.com 5