– and that when you think about ProduCt purchasing additional audio equipment for your home, car or The JBL Cinema SB200 powered soundbar speaker is a complete, office, you will once again choose JBL products. integrated sound system that will dramatically improve the sound of programs you watch on your television.
SouNdBAr PLACEMENt 4. After reading the Connections section on page 4, connect all cables to the soundbar. PLACING THE SOUNDBAR ON A TABLE IMPORTANT: Do NOT plug the soundbar’s power cord into an AC If your TV is placed on a table, you can place the soundbar on the table outlet at this time.
CoNNECtIoNS NOTE: If your disc player, cable tuner or satellite tuner does not have an optical digital output, you can connect its analog audio output to your SOURCE CONNECTIONS TV. The TV will send its audio signal to the soundbar through the analog connection described above.
POWER CONNECTIONS BLUETOOTH OPERATION After verifying that all of the source connections have been made properly, To wirelessly stream audio to the soundbar from a Bluetooth-enabled plug the supplied power cord into the soundbar’s Power Cord connector, device: and plug the other end into an active, unswitched AC outlet. Do NOT plug this cord into the accessory outlet found on some audio components.
ADJUSTING THE SYSTEM’S VOLUME BooStINg thE BASS Press the soundbar’s or remote’s Volume + and – buttons to raise and Press the remote’s Bass Boost button to enhance low-frequency lower the system’s volume one step at a time. Hold down the buttons performance, resulting in bass with more impact, which you may to continuously raise or lower the volume.
• Press the TV remote’s volume down button while pressing and holding the soundbar’s Volume – button. If the programming was successful the soundbar’s Surround button will change from amber CINEMA SB200 POWERED SOUNDBAR SPEAkER to solid white for one second, then will return to flashing amber. Low-frequency transducer: One 3-1/2"...