Ariston Genus 27 Plus User Manual page 9

403
Reading the programmed switching times
Pressing the "Prog" key displays the programmed switching times until the
first free memory location appears in the display "– – : – –".
If you now press the "Prog" key once again, the number of free memory
Iocations will be displayed, e.g. "FR 1 1 8 8 ". If all memory locations are
occupied, the display "FR 0 0 0 0 " appears.
Changing the programmed switching times
Press the "Prog" key repeatedly until the switching time you want to change
is displayed. You can now enter the new data. See point "Entering the
switching times".
Notes on storing switching times:
If you end your entry of the switching times by pressing the "Prog" key, then
the switching time you have entered will be stored and the next memory
location displayed. Entry of further switching times is also carried out as
described in point 4.3.
In addition, a complete switching command is stored automatically after
around 90 seconds provided no other key is pressed. The time switch then
enters the automatic operating mode and displays the current time again.
Deleting individual switching times
Press the "Prog" key repeatedly until the switching time you wish to delete
is shown in the display. Then set to "– –" using the "h" or "m" key and keep
the " " key pressed down for around 3 seconds. The switching time is now
erased and the current time is displayed.
AM / PM time display
If you press the "+/-1h" and "h" keys at the same time, the time display
switches into the AM/PM mode (mostly used in English-speaking countries).
Technical data
Connection
Switching capacity
Ambient temperature
Running reserve
Memory Iocations
Shortest switching time
Programmable
see unit imprint
see unit imprint
-10°C to +55°C
5 h at + 20°C
20
1 min.
every minute
9