Panasonic TH-43LFE8W Operating Instructions Manual page 79

6
Select [YES] with
<ENTER>.
Data copy to the USB memory starts.
Data to USB Memory
The data will be overwritten when any data exists originally.
Are you OK to write the data?
YES
The following message is displayed after data copy
has finished.
Data copy finished.
7 After data copy has finished, remove
the USB memory device from the USB
terminal.
Copying the USB memory data to the
display
1 Insert the USB memory device, which
the data has been copied, to the USB
terminal of the display for data copy
(same as the step 1 on page 78).
Note
If the USB memory containing the data for cloning
is connected in power-on state, the [Select Copy
Type] message in step 5 is displayed. Select [USB
2 Display [Setup] menu pressing
<SETUP>.
3
Select [OSD Language] with
press <ENTER> for over 3 seconds.
The following display appears.
Options
Display serial number
Software licenses
USB data cloning
Shipping
4
Select [USB data cloning] with
and press <ENTER>.
5
and press <ENTER>.
Select Copy Type
and press
NO
and
6
Select [YES] with
<ENTER>.
Data copy to the display starts.
Data from USB Memory
Do you copy the data?
YES
The following message is displayed after data copy
has finished.
Cloning finished.
Please turn off the power.
7 After data copy has finished, remove
the USB memory device from the USB
terminal.
8
Press the power switch (
display unit to turn the power OFF,
and turn the power ON again.
The copied content is applied to the display.
and press
NO
) of the
English
79