Flash Diffuser 0591.3; Using The Diffuser; Diffuser Installation And Removal - Ikelite DS160 Instruction Manual

FLASH DIFFUSER 0591.3

USING THE DIFFUSER

The white diffuser can be secured to the front of the DS160 Strobe when softer lighting or
a coverage angle of 100° is desired.
The diffuser reduces the DS160's light intensity by one full f-stop.

DIFFUSER INSTALLATION AND REMOVAL

1. Position the Diffuser Cut-outs over the DS160's Diffuser Retention Tabs.
2. Press down lightly until the diffuser is flush against the strobe face.
3. Rotate the Diffuser Installation Posts either direction until the Posts stop
against the strobe's Diffuser Retention Tabs.
4. Reverse process to remove the Diffuser.
A lanyard or string can be attached to the diffuser by threading it through the two
Lanyard Holes near its edge. Attach the other end to the strobe to prevent
accidental loss.
Flash Diffuser
Installation Post
Diffuser
Cut-outs
Lanyard Holes
DS160 Strobe
Diffuser Retention Tab
11