Vision TECHCONNECT TC2-HDMIP Owner's Manual page 8

Connecting IR Blasters
It is possible to point your source remote control at the Rx, and it will relay the IR signal back to
the source/s wirelessly.
1. CONNECT IR EMITTER TO TX Correct cable has
2 x IR emitter diodes inline to control two
source devices. Position them directly over the
IR receivers on the source equipment.
2. [OPTIONAL] CONNECT IR RECEIVER TO RX Correct cable has 1 x IR receiver diode. If
receiver will be hidden out of sight use the IR receiver cable. Place near display so it can
capture commands from source remote controls/s.
NOTE 1: when receiver cable is
plugged in receiver on rx chassis is
disabled
NOTE 2: The IR sensors support
36~56kHz signal protocol. Some
devices may not be supported.
8
TC2-HDMIP_manual_en