Receiver ("Rx") - Vision TECHCONNECT TC2-HDMIP Owner's Manual

RECEIVER ("Rx")

1. Source LEDs (lit solid green to show active input)
2. Link LED (Solid green = paired / flashing green = establishing connection or unable to
connect)
3. Source Select button
4. Power LED (Solid green = on / solid red = off)
5. Power button
1. Reset Button (hold down to do factory reset back to default settings)
2. Power Input (C5 "Cloverleaf")
3. IR OUT plug IR receiver cable in here (only needed if receiver hidden out of sight)
4. HDMI output (type A)
5. Service (USB-A) (plug USB stick in here to update firmware if instructed)
1
1
3
2
4
2
5
4
3
5
5
TC2-HDMIP_manual_en