Table of Contents
Advertisement
5
AC POWER CONNECTIONS
AC Power cords
AC Power cord connections
1
Loosen the 2 screws and remove the protection plate of the control box (image 5.1).
2
Use the supplied power cord to connect the projector to the power strip (image 5.1).
3
Connect the power cord of the power strip to the wall outlet (image 5.1).
Control box
Vacuum pump
image 5.1
AC Power cord connections
Preparing the power cord
As the colors of the wires in the mains lead of this apparatus may not correspond with the colored markings identifying the terminals
in your plug, proceed as follows:
1
The yellow/green wire is ground and must be connected to the terminal in the plug which is marked by the letter E or colored
yellow and green.
2
The blue (white) wire is neutral and must be connected to the terminal marked with the letter N or colored black.
3
The brown (black) wire is the line and must be connected to the terminal marked with the letter L or colored red.
image 5.2
Power cord plugs
5976418 BARON 908 04122001
Control unit
CEE 7 Plug
Green and yellow : Ground
Blue : Neutral
Brown : Line
Projector
OFF
ON
POWER MAINS
REMOTE
Projector to
power strip
Power strip
Fuse holder
ANSI 73.11 Plug
Green and yellow : Ground
White : Neutral
Black : Line
AC Power connections
800 periphals
COMM. PORT
PORT 3
IR
RS 232 OUT
RS 232 IN
Power strip
to wall outlet
5 - 1
Advertisement
Table of Contents
