Electronic Speed Control Setup; Driving - Maverick Strada EVO Instruction Manual

Electronic Speed Control Setup

MSC-22 Brushed ESC
1. With the speed control switch set to off, plug in a suitable battery pack.
2. With the transmitter switched on and throttle trim set to the centre, turn on the speed control.
3. To Indicate the speed control is working correctly its LED will flash followed by 3 beeps and a further flash.
4. If necessary adjust the throttle trim of the transmitter so your car is stationary with no throttle or brake applied.
5. Your speed control is fully installed and ready to use.
Technical Information
•
PWM frequency 1.5khz (fixed)
•
200 A drive FET's & 100A Reverse FET's
•
Case dimensions: 33mm*27mm*25mm
•
Silicone Wire 14 Gauge
•
Weight 45g with connectors and switch
•
BEC Voltage 6.0V
MSC-22BL Brushless ESC
1. With the speed control switch set to off, plug in a suitable battery pack.
2. With the transmitter switched on and throttle trim set to the centre, turn on the speed control.
3. The ESC will automatically set itself to your transmitter and should be ready to use.
Technical Information
•
PWM frequency 10K
•
80 Amps continuous current
•
Case dimensions: 32mm*43mm*36mm
•
Silicone Wire 14 Gauge
•
Weight 72g with connectors and switch
•
BEC Voltage 6.0V 3A
MM-22BL Brushless Motor - 3215KV

Driving

Driving an R/C car can be very difficult to master but here are some basic tips to help you to understand how to use it before you have your first
attempt
•
Drive the vehicle in a very large space, especially until you get the feel of driving the product.
•
Do not run on public streets or highways. This could cause serious accidents, personal injuries and/or property damage.
•
Do not run in water or sand.
•
If you keep pulling the throttle trigger on the transmitter, the vehicle will keep accelerating and run very fast. It is difficult to steer the
vehicle running at high speed until you become used to driving. Drive the vehicle slowly by pulling the throttle trigger to the fullest and
quickly releasing it.
You can turn the vehicle right or left while it is running.
When the vehicle is running toward you, you need to operate the steering wheel in the opposite direction to the operation when the vehicle is
running away from you.
Practice turning the vehicle, referring to the following:
Rather than just paying attention to the direction of the steering wheel, imagine that you are at the centre of the steering wheel, looking ahead of
the vehicle, to turn in the direction you like.
Once you become conformable driving the vehicle, practice driving on a track with cones.
Keep practising until you feel comfortable with the steering, throttle and brake at low speeds.
Once you are feeling comfortable try using reverse.
When you have mastered the basics you will be able to drive at higher speeds in a more controlled fashion.
Features
•
6.0Volt — 8.4Volt Power Input
•
High Frequency Drive System
•
Forward, Reverse & Brake Linear Operation
•
Automatic Setup System
•
Over Current Protection
•
Thermal Protection
•
Low Voltage Protection
•
LED with audible beep
•
13 Turn Brushed Motor Limit
Features
•
5.0 Volt — 8.4 Volt Power Input
•
High Frequency Drive System
•
Forward, Reverse & Brake Linear Operation
•
Automatic Setup System
•
Over Current Protection
•
Thermal Protection
•
Low Voltage Protection
•
LED with audible beep
•
11 Turn Brushless Motor Limit 50,000 RPM Max
5
DISCONNECT THE BATTERY
PACK AFTER USE!