Word Clock Reference Output; Ac Power Entry Connector; Fuse Holder - Benchmark ADC1 Instruction Manual

Word Clock Reference Output

This output provides a Word Clock signal for
use with downstream components.

AC Power Entry Connector

The AC power input uses a standard IEC type
connector. Within the USA and Canada, the
ADC1 ships with a power cord. In other
locations, a location-specific IEC style power
cord may be purchased from a local source
(including a local Benchmark dealer).

Fuse Holder

The fuse holder is built into a drawer next to
the IEC power connector. The drawer requires
®
two 5 x 20 mm 250 V Slo-Blo Type fuses.
The drawer includes a voltage selection switch
with two settings: 110 and 220. Both settings
use a 0.5 Amp fuse.
The AC input has a very wide input voltage
range and can operate over a frequency
range of 50 to 60 Hz. At 110, the ADC1 will
operate normally over a range of 95 to 140
VAC. At 220, the ADC1 will operate normally
over a range of 190 to 285 VAC.
CAUTION: ALWAYS REPLACE THE FUSES
WITH THE CORRECT SIZE AND TYPE.
ADC1 Instruction Manual Page 10