Engine - Northern Lights OM844W3 Operator's Manual

For models: m844w3; m844lw3; m20crw3
Hide thumbs Also See for OM844W3:
Table of Contents

Advertisement

ENGINE

PROBLEM
Engine Hard to Start
or Will Not Start
Engine Runs Irregularly
or Stalls Frequently
Lack of Engine Power
Troubleshooting
POSSIBLE CAUSE
Improper starting procedure
No fuel
Low battery output
Excessive resistance
in starting circuit
Crankcase oil too heavy
Improper type of fuel
Water, dirt or air in fuel system
Clogged primary
fuel fi lter element
Lift pump malfunction
Clogged secondary
fuel fi lter element
Dirty or faulty injection nozzles
Below normal engine temperature
Clogged primary
fuel fi lter element
Clogged secondary
fuel fi lter element
Water or dirt in the fuel system
Dirty or faulty injection nozzles
Air in fuel system
Control lever adjusted incorrectly
Improper type of fuel
Uneven compression pressure
between cylinders.
Intake air restriction
Clogged primary
fuel fi lter element
Clogged secondary
fuel fi lter element
Injection pump not getting fuel
Improper type of fuel
OM844W3 5/11
25
RECOMMENDATION(S)
• See starting section of this manual. Take
special note of Bypass Switch operation.
• Check level of fuel in fuel tank.
• Check electrolyte level and condition.
• Clean and tighten all battery connections.
• Use oil of proper viscosity.
• Consult fuel supplier and use proper type
of fuel for operating condition.
• Drain, fl ush, fi ll and bleed system.
• Clean or replace fi lter element.
• Repair lift pump.
• Replace fi lter element.
• Have your dealer check injection nozzles.
• Remove and check thermostat.
• Clean or replace fi lter element.
• Replace secondary fi lter element.
• Drain, fl ush, fi ll and bleed system.
• Have your dealer check injection nozzles.
• Inspect clamps and hoses on suction side
of fuel pump for air leak.
• Adjust control lever
• Consult fuel supplier and use proper type
of fuel for operating condition.
• Check cylinder compression pressure.
• Service air cleaner, check proper ventilation.
• Clean or replace fi lter element.
• Replace fi lter element.
• Have injection pump checked.
• Consult fuel supplier and use proper type of
fuel for operating conditions.

Advertisement

Table of Contents
loading

Table of Contents