Ford KUGA Owner's Manual page 249

Turning Traffic Announcements On and
Off
Before you can receive traffic
announcements, you must press either the
TA or TRAFFIC button. A TA display will
appear to show the feature is switched on.
If you are already tuned to a station that
broadcasts traffic information, TP will also
be displayed. Otherwise the unit will search
for a traffic program.
When traffic information is broadcast, it
will automatically interrupt normal radio
or CD playback and Traffic announcement
will appear in the display.
If a non-traffic station is selected or
recalled using a preset button, the audio
unit will remain on that station unless TA
or TRAFFIC is turned off, then on again.
Note: If traffic announcement is on and you
select a preset or manual tune to a non
traffic announcement station no traffic
announcement will be heard.
Note: When you are listening to a non
traffic announcement station and turn
traffic announcement off and on again a TP
seek will occur.
Traffic Announcement Volume
Traffic announcements interrupt normal
broadcasts at a preset minimum level that
is usually louder than normal listening
volumes.
To adjust the preset volume:
• Use the volume control to make the
necessary adjustment during an
incoming traffic announcement
broadcast. The display will show the
level selected.
Kuga (CBS) Vehicles Built From: 08-09-2014 Vehicles Built Up To: 31-05-2015, CG3585en enGBR, Edition date: 08/2014, First Printing
Audio System
Ending Traffic Announcements
The audio unit will return to normal
operation at the end of each traffic
announcement. To end the announcement
prematurely, press TA or TRAFFIC during
the announcement.
Note: If you press TA or TRAFFIC at any
other time it will switch all announcements
off.
Automatic Volume Control
When available, automatic volume control
adjusts the volume level to compensate
for engine noise and road speed noise.
1. Press the MENU button and select
AUDIO.
2. Select Adaptive vol.
3. Use the left or right arrow button to
adjust the setting.
4. Press the OK button to confirm your
selection.
5. Press the MENU button to return.
Digital Signal Processing
Digital Signal Processing Occupancy
This feature takes into account the
differences in distance from the various
speakers in your vehicle to each seat. You
must select the correct sitting position for
the audio to be correctly set.
Digital Signal Processing Equalizer
Select the music category that most suits
your listening preference. The audio output
will change to enhance the particular style
of music chosen.
Changing the Digital Signal Processing
Settings
1. Press the MENU button.
2. Select AUDIO or Audio settings.
247