Advertisement
VI / UTILISATION EN ALUMINIUM
The torch installation for aluminum is fundamental.
The essential precautions are the following:
- Don't use the brass capillary tube in the euro adapter, but
use the Teflon envelope, which must come until the moto-
wire feeder roller.
- In ALUMINIUM, use a contact tube of a diameter
immediately superior to the section of the wire used.
- Use ALU rollers identical with wire diameter.
VII / OPTION FOR MIG PRO 41/35
The MIG PRO 41/35 is an evolutive welding machine. From origin machine, we can only use this one with the
moto wire feeder. Then, we can advanced the product with separated wire feeder with equipping it with a WF
wire feeder and a contact batch from 5 or 10 meters.
When the machine is fully equipped, the choice of the moto wire feeder will be in function of the commutator
position in foreside.
Origin moto-wire feeder
on the generator
Connection from a wire feeder WF to the generator
Gas pipe
Control cable
Power cable
VIII / MAINTENANCE
You must clean out and replace regularly nozzle and contact batch of all projections. Use a spray of anti-pearl
aerosol.
We advice you to clean the covering situated in the torch by blowing it with compressed air.
IX / ADJUSTMENTS OF WELDING CYCLES : PREGAZ, POSTGAZ, BURNBACK
The advanced electronic card allows to intervene on the welding parameters.
To go on ADJUSTMENT mode, you have to (when the machine is working) press during 3 seconds on the button
« MODE ». Then, every indicators switch off and the higher display indicate PRE and the lower display indicate
the PREGAZ value. This value can be modified by pressing on + or -. If you press again on, you will adjust the
POSTGAZ time (POS on the higher display). If you press a third time, you will adjust the late time to the fusion
Option wire feeder WF
Do not forget to
transpose the gas
connection situated
behind the front
panel
To use a wire feeder WF,
tip the commutator on the
position II « wire feeder
WF »
7
Advertisement
