Advertisement
Quick Links
INSTRUCTION MANUAL
FOR SEMI-AUTOMATICAL
WELDING MACHINES
IMS MIG PRO 41/35
EC MARKING
This product has been designed in respect of the Low Voltage Directives 73/23 EEC dated 19th
February 1973 (amended 93/68/EEC) and the electromagnetic compatibility directives EMC
89/336/EEC dated 3rd May 1989, (amended 92/31/EEC, 93/68/EEC,1 91/263/EEC).
This conformity is established in compliance with the standardized norms EN 50199 dated 1995
(Directive EMC), EN 60974-1 dated 1998, and amendments A1 dated 2000 and A2 dated 2003.
Mise à jour
: 26/06/06
Réf 73502
MIG 7
1
Advertisement
Related Manuals for IMS MIG PRO 41
Summary of Contents for IMS MIG PRO 41
- Page 1 INSTRUCTION MANUAL FOR SEMI-AUTOMATICAL WELDING MACHINES IMS MIG PRO 41/35 EC MARKING This product has been designed in respect of the Low Voltage Directives 73/23 EEC dated 19th February 1973 (amended 93/68/EEC) and the electromagnetic compatibility directives EMC 89/336/EEC dated 3rd May 1989, (amended 92/31/EEC, 93/68/EEC,1 91/263/EEC).
- Page 2 Thank you for choosing our product! Before installing and using the product, or maintenance, please read carefully the following recommendations about safety norms in order to avoid accidents to the users and damages of the welding process. GYS can’t be responsible for the damages occurred to persons or things, which derive from the use of the machine in following circumstances: - Modification or neutralization of safety elements, - Non respect of the recommendations written in the manual instruction,...
-
Page 3: Electromagnetic Compatibility
Poste MIG PRO 41 / 35 Protection of the line : Fuse 25A curve D ou fuse 25A type aM III/ DESCRIPTION OF THE MACHINE MIG PRO 41/35 : Higher part Indicator of VOLTAGE Potentiometer of instructions WIRE SPEED wire speed. - Page 4 MIG PRO 41/35 : Foreside (Lower part) connection Generator wire feeder Selection commutators of the output allows to lay in gas (connected to positive terminal). voltage. Terminal – generator wire superior current feeder type WF. The (position for an using in connection SPRAY ARC).
-
Page 5: Stainless Steel
For an application with a wire in normal polarity, you must connect the adapter earth clamp on the negative terminal and take care to swivel from a ¼ the adapter. The MIG PRO 41/35 can only works on normal polarity (+ on the torch ) if we use the wire feeder of the generator. - Page 6 Too blocked: the motor is in difficulty and the WIRE risk not to drive. Release: the important coil inertia can drive the wire rolling after end welding. Open the gas. The machine is ready to operate. V / INDICATIVE ADJUSTEMENTS AJUSTMENT FOR MIG PRO 41/35 FOR STEEL USE INDICATIVE ADJUSTMENT COMMUTATOR WIRE SPEED...
-
Page 7: Maintenance
VII / OPTION FOR MIG PRO 41/35 The MIG PRO 41/35 is an evolutive welding machine. From origin machine, we can only use this one with the moto wire feeder. Then, we can advanced the product with separated wire feeder with equipping it with a WF wire feeder and a contact batch from 5 or 10 meters. - Page 8 (BURNBACK) or the free wire length (Bur on the higher display). To come back in normal mode, you have to press again on MODE. If, by mistake, the modified parameters doesn’t correspond anymore to the user wishes, you can put back the welding parameters from the factory. For that, you must switch off the machine.